Prolimatech MK-26 Multi-VGA Cooler
Sorry for the slight angle, but I have to prop the right side of the MK-26 to get it even close for images. On the left there are 20 fins, six 6mm heat pipes and the base in the middle, and then the heavier side of the cooler with its 45 fin arrangement.
At the end of the longer section of the MK-26, Prolimatech puts its name as well as the name of the cooler on the end fin. This is what will be the end nearest the HDD bays in a typical case.
Spinning the MK-26 around, the only thing that changes is the view of the heat pipes and base of the cooler. Of course the fin arrays swapped sides as well, but that large opening in the middle is really put to good use.
This is the end of the shorter section, and as you can see without the name plate that covered the other side, these fins are all made from two pieces, connected together, and then slid onto the hat pipes.
Looking down into the cooler, you can see why there was the need for the wide gap over the base plate in this cooler design. There is just no effective way to get these sorts of runs and bends and still get any aluminum on there.
Looking in a little closer, you can see that the top of the base plate has been grooved which allows it to be a heat sink in itself. Since the fan will be over this area, I like that the pipes and the base get a great flow of air even before the heat reaches the fins.
Flipping the MK-26 over to expose the underside of it doesn't show much that we didn't assume it would be from all of the other angles. For shipping protection, there is a plastic sticker in place to protect the base of the cooler. Make sure to remove this prior to use.
Zooming in on the base of the MK-26 you can still see the milling marks, but the base is really level across all angles. The three holes in the base will come into play later, but the two on either side of the base allows for the Omni-Mount system to be used.
Page 4 of 9
Further Reading: Read and find more Cases, Cooling & PSU content at our Cases, Cooling & PSU reviews, guides and articles index page.
Do you get our RSS feed? Get It!